ShoreTel SA-100, Installation Manual

Page: 29 / 84

Chapter 4: Site Requirements and Preparation SA-100 Planning, Installation, and Administration Guide
ShoreTel 12.3 29
4.2.2 Back Panel
This section provides information about the SA-100 back pane. Figure 4-2 and Table
4-4 provide information about the SA-100 back panel.
Figure 4-2 SA-100 Rear Panel indicators and Connectors
Table 4-3 SA-100 Front Panel Indicators and Connectors
Item
Indicator, Button, or
Connector
Description
1 Power-on indicator/
power button
The power-on indicator lights when the system power
is on.
The power button controls the internal power supply
output to the system. When the system bezel is
installed, the power button is not accessible.
2 VGA Connector Not used.
3 Hard drive activity
indicator
Lights up when the hard drive is in use.
4 Diagnostic indicator
lights
The four diagnostic lights display error codes during
system startup. See “Diagnostic Lights” in the ShoreTel
Maintenance Guide.
5 System status
indicator
Lights blue during normal system operation. Lights
amber when the system needs attention due to a
problem.
6 System
identification button
Activates indicator lights on the front and back panels
that facilitate locating the unit in the rack.
7 (2) USB Connectors Allows you to connects USB devices to the unit for
system recovery. The ports are USB 2.0-compliant.
8 Slide-out system
Identification panel
The top contains the ShoreTel product ID, part
number and serial number. The bottom contains two
MAC addresses for the two internal NICs.