Sharp SF-DM11, Service Manual

Page: 61 / 141

10. Adjust the positions of the front and rear side
plates.
Remove the mounting screws (two each) which secure the front and
rear side plates, fit the two side plates into the appropriate positions
marked on the cassette corresponding to the desired paper size, and
then secure the side plates once again with the mounting screws (two
each).
11. Adjust the position of the rear edge plate.
Remove the rear edge plate and fit it into the cassette at the position
corresponding to the desired paper size.
12. Set the paper size detection spacer.
Change the position of the paper size detection spacer to the position
corresponding to the desired paper size.
Paper size detection spacer position diagram
13. Change the paper size indicator.
Remove the paper size indicator and re-insert it so that the paper size
for which the cassette has been set is visible in the paper size indica-
tion window.
Note that paper size indications are printed on both sides of the paper
size indicator.
Front side plate
Rear side plate
Screws
Screws
Rear edge plate
Paper size delection spacer
(Example: Position for A3 size paper)
A4
A4R
A5
B4
B5
A3
B5R
AB system
EXTRA
8 1/2 x 11
11 x 17
8 1/2 x 14
8 1/2 x 11R
Inch system
EXTRA
Paper size indicator
5 – 32