Sharp SF-DM11, Service Manual

Page: 70 / 141

4. Remove the toner collecting container.
Open the toner collecting container cover, pull the fixed lever forward,
and remove the container.
5. Remove the cover plate.
Remove the cover plate by removing the screw which secures it.
6. Install the paper feed unit.
Fit the groove in the paper feed unit into the guide rail, and then,
while tilting the paper feed unit at an angle of approximately 30°, slide
it all the way back as far as it will go.
Fit the paper feed unit into the positioning bosses (two locations) on
the desk frame, and secure it with one mounting screw B.
7. Remove the packing screw from the paper
cassette.
Remove the packing screw which secures the paper pressure plate
inside the paper cassette.
The paper size is set to A4 for AB system and 8
1
⁄
2
" x 14" for inch
system at the factory.
8. Change the positions of the front and rear side
plates.
Remove the mounting screws (2 each) which secure the front and
rear side plates, fit the front and rear side plates into the appropriate
locations marked on the cassette to set the desired paper size, and
then secure the side plates once again with the mounting screws (2
each).
9. Position the rear edge plate.
Remove the rear edge plate from its storage slot and fit it into the
cassette to set the desired paper size.
The rear edge plate is not needed to set the paper size to 11" x 17"
(double letter size).
Fixed lever
Toner collecting container
Cover
Mounting screws
Cover plate
Guide reil
Paper feed unit
Mounting
screw B
Packing screw
Front side plate Mounting
screws
Rear side plate
Mounting screws
Rear edge plate
Rear edge plate storage slot
5 – 41