Sharp SF-DM11, Service Manual

Page: 124 / 141

Main code Sub code Description Ref. Page
24 01
°
Misfeed map memory and total misfeed counter clear
03
°
RADF counter clear
The contents of the copy number counter is reset for the RADF.
It is mandatory to clear the memory contents after the maintenance is completed.
04
°
Duplex counter clear
The contents of the copy number counter is reset to the duplex unit.
It is mandatory to clear the memory contents after the maintenance is completed.
05
°
Staple counter clear
The staple unit using counter is cleared to zero.
06
°
Developer adjustment time clear
The developer adjustment time is cleared to zero.
07
°
Drum adjustment time clear
The drum adjustment time is cleared to zero.
08
°
Tray paper feed counter clear
Used to clear the tray paper feed counter.
25 01 Main motor activation
•
Used to check malfunction in the main motor drive train. (Rotates for 3 min.)
•
Also, monitors the toner density sensor. (Sensor output value display)
C
→
=
↵ →
0
→
=
↵ →
2
→
5
→
PSW
→
1
→
PSW
02 Automatic developer adjustment
•
This is the test command used to monitor the toner sensor and to automatically set the developer.
•
For automatically setting developer, the developing tank is stirred and the toner sensor output is
monitored. The sensor is monitored 16 times in 3 minutes after the stirring started and the mean
value is stored in the memory as the toner density referance value. (See the area marked with an
asterisk in the figure below.) ( Afterwards, referance changes as copies are made to maintain
density.)
C
→
=
↵ →
0
→
=
↵ →
2
→
5
→
PSW
→
2
→
PSW
26 01 Option unit setup
•
Used to set up option unit.
1
When the test command is executed, the presently stored machine setup code is displayed with the
READY lamp turned on.
2 After the READY lamp has turned on, enter an appropriate setup code on the keypad and press the
PRINT switch. Then, the date is stored in the memory and the READY lamp turns off.
Code Option
+1 RADF
+2 ADU
+4 Desk
+10 Sorter
°
No need to set "+2 (ADU)". If the ADU is installed, "2" is automatically added.
°
Used to set the code that corresponds to an option unit.
(EX): To set the RADF and desk together with ADU, enter 1+2+4=7, or 1+4=5.
NOTES:
(1) Be sure to enter the code that corresponds to the installed option unit.
(2) If option setup is incorrect, a trouble code is displayed. See the trouble code chart.
03 Coin vendor setting
0: Cancel, 1: Setting
MM
DVBIAS
THV
DL
3min
900msec
100m
sec
8 – 9