Sharp Notevision PG-M25X, Operation Manual

Page: 78 / 131

-74
Network Settings (cont.)
Wireless LAN PC Card: Troubleshooting
Check the following if you cannot connect to the network using your wireless LAN PC card.
1. Is the Link indicator of the wireless LAN PC card lit?
•
Lit: operating normally.
•
Flashing: the wireless LAN PC card is not operating properly. Consult with your nearest dealer.
•
Off: The card is not in operation. Make sure that the card is installed correctly.
2. Are the SSID and channel settings of the projector and computer the same?
•
If the SSID and channel settings of the computer are not the same, then they cannot communicate.
•
Make sure that the transmission mode has been set to 802.11 ad hoc mode.
3. Check the projector and computer network settings.
●
When the “DHCP Server” on the projector is “OFF”:
Check again the IP address, subnet mask and gateway values of the projector and computer.
●
When the “DHCP Server” on the projector is ON:
Check the values of the IP address, subnet mask and DHCP start address of the projector.
If part of the IP address or DHCP start address is not identical to the ones specified in the subnet mask,
IP address assigning cannot be properly done.
4. When sending the screen to the projector, make sure to turn on the projector first.
When Standby is displayed on the screen, turn on the computer.
If the above procedure is carried out and the wireless LAN PC card still does not operate, see the Wireless
Reality software operation manual.
192.168.150.120
255.255.255.0
192.168.150.100...correct
192.168.050.100...wrong
IP address
Subnet mask
Start address
Start address
Resetting the Network
Settings
This will return the default values of the
Network Settings.
Select “Reset” in the Network menu on
the menu screen.
When the confirmation screen is dis-
played, select “YES” using or and
press .
➝
For operating the menu screen, see
pages 50 to 55 .
Note
•
If a password has been set, the password
input box will be displayed when selecting
the “Reset”.