Sharp Notevision PG-M25X, Operation Manual

Page: 31 / 131

Setup and Connections
-27
1
DVI to 15-pin D-sub cable
Connecting the Projector to a Computer
Connecting to a Computer
Using the
DVI to 15-pin
D-sub Cable
1
Connect the projector to the
computer using the supplied
DVI to 15-pin D-sub cable.
•
Secure the connectors by tightening
the thumbscrews.
2
To input audio signal, connect
the projector to the computer
using a ø3.5 mm stereo audio
cable (commercially available
or available as Sharp service
part QCNW-4870CEZZ).
Note
•
See page 115 “Computer Compatibility
Chart” for a list of computer signals com-
patible with the projector. Use with com-
puter signals other than those listed may
cause some of the functions not to work.
•
When connecting the projector to a com-
puter in this way, select “RGB” for “Signal
Type” in the “Picture” menu. See
page 59 .
•
A Macintosh adaptor may be required for
use with some Macintosh computers. Con-
tact your nearest Shar p Authorized
Projector Dealer or Service Center. See
page 118 .
Connecting the thumbscrew cables
■
Connect the thumbscrew cable making sure that it
fits correctly into the port. Then, firmly secure the
connectors by tightening the screws on both sides
of the plug.
■
Do not remove the ferrite core attached to the DVI
to 15-pin D-sub cable.
Ferrite core
Supplied
accessory DVI to 15-pin
D-sub cable
To RGB Output port
To Audio Output port
Notebook computer
2
ø3.5 mm stereo audio
cable (commercially
available or available as
Sharp service part
QCNW-4870CEZZ)