Sharp AR-6020, Operation Manual

Page: 40 / 139

40
BEFORE USING THE MACHINE
Loading the bypass tray
1
Unfold the bypass tray.
When feeding large
paper such as B4 and A3
(8-1/2" x 14" and
11" x 17"), open the
bypass tray extension.
2
Set the paper guides to the copy
paper width.
3
Insert the paper (print face down) all
the way into the bypass tray.
To prevent a misfeed,
verify once more that the
paper guides are
adjusted to the width of
the paper.
Important points when inserting paper in the bypass tray
• Up to 100 sheets of standard copy paper can be set in the bypass tray.
• Be sure to place A6, B6 or 5-1/2" x 8-1/2" size paper or envelopes horizontally as shown in the following diagram
( ).
• When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction flaps
(not the closure flap).
• Special papers except SHARP recommended transparency film, labels, and envelopes must be fed one sheet at a
time through the bypass tray.
• When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then
reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.
• Do not use paper that is smaller than the original. This may cause smudges or unclean images.
• Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause
smudges or unclean images.
• If you loaded paper in the bypass tray,
press the [TRAY] key to select the bypass
tray. The bypass tray will not be selected
automatically.
• When loading heavy paper in the bypass
tray, hold down the [PAPER] key for at least
5 seconds, use the [TRAY] key to select the
bypass tray, and press the [Copy ratio] key
(
,
) to select “1” for Heavy Paper 1
or "2" for Heavy Paper 2. For the types of
heavy paper that can be used, refer to
"PAPER" (p.38) .
Note
Available
Not
available