- 52 -
DATA Transference Method selection
●
0
Simplex Mode / Stream Mode
F62
1
Duplex Mode / Command Mode
※
Under Command Mode setting(F62-01), you can not use serial port 1. to use Data transference or
printing purpose. So the following “F-functions, F65, F66, F67, F68” will not be activated.
So, ignore the F65, 66, 67, 68 settings.
Under Command Mode setting(F62-01), F63, and F64 function will be activated.
※
If you want to fix “Serial Port 2.” for Command mode, and you also want to data transference or
print purpose, you have to set the F32-00, and F35-01 or 02.
Print port selection (Under F62-01 setting, only)
●
0
Same port as using for Command Mode.
F63
1
The other port.
※
Through this function, you can selection print port, where indicator takes a “Print Command” from
P.C. If you choose F63-00, the print data will be transfer to P.C with print format. If you choose the
other port, the print data will be transfer through the other port.
If you set F63-01, but you just connect with another P.C, you can take print data with print format
though the another P.C
※
The transferred data format is same as print format, not a data format(please refer “Print Interface
section”)
“Check-Sum” detection selection (Under F62-01 setting, only)
●
0
Check-Sum data will not be included on transferred data.
F64
1
Check-Sum data will be included on transferred data.
Serial Port Application Selection (Under F62-00 setting, only)
●
0
DATA
Transference
purpose
F65
1
Printing purpose (Serial Printer)
※
Under “DATA Transference” Mode(F65-00), F66,67 function will be activated.
Under “Print Purpose” Mode(F65-01), F68 function will be activated.
