sewerin ATS 501, Operating Instructions Manual, Page: 6 / 79

II │ Contents
5.2 Utilisable test gases ................................................................26
5.3 Available test gases ................................................................27
5.4 Planning for gas assignment ...................................................27
5.5 Connecting test gases .............................................................28
5.5.1 Screwing on the test gas can ...............................................28
5.5.2 Connecting a test gas bottle .................................................29
5.6 Assigning test gases to test gas connections (gas
assignment) .............................................................................29
5.7 Non-use of test set ..................................................................30
6 Settings ..................................................................................31
6.1 General information about the settings ...................................31
6.2 Settings using the GasCom software ......................................31
6.3 Settings using the test set .......................................................32
6.3.1 Possible settings ..................................................................32
6.3.1.1 Gas assignment ................................................................32
6.3.1.2 ATS mode .........................................................................32
6.3.1.3 Device inspection mode ....................................................33
6.3.1.4 Timer .................................................................................34
6.3.2 Changing settings ................................................................34
7 Device inspections ...............................................................36
7.1 Ways of carrying out the procedure ........................................36
7.2 Requirements ..........................................................................36
7.3 Features ..................................................................................37
7.3.1 All operating modes .............................................................37
7.3.2 Manual operating mode: Special features and variants of
the device inspection ............................................................37
7.3.3 Automatic and Timer operating modes: Special features .....38
7.4 Subtests ..................................................................................39
7.5 Due date ..................................................................................40
7.6 Presentation of results ............................................................40
7.7 Performing the device inspection ............................................41
7.7.1 Manual operating mode .......................................................41
7.7.2 Automatic and Timer operating modes ................................43
8 Adjusting devices ................................................................45
8.1 Ways of carrying out the procedure ........................................45
8.2 Requirements ..........................................................................45
8.3 Frequency ...............................................................................45