12
│ 3 Preparing for start-up
Setting up the test set in a tilted position (fig. 7)
1. Pull the supporting bracket down vertically. Remove the sup-
porting bracket. 1
2. Plug the device plug of the AC/DC adapter into the power
supply connection of the test set.
3. Slide the supporting bracket into the test set. 2
−
Insert the pins into the slots on both sides.
4. Push the supporting bracket upwards as far as it will go. 3
5. Pivot the bracket as far as it will go. Tilt the test set until it is
securely supported by the bracket. 4
3.2.3
Wall mounting
For wall mounting, the supporting bracket is screwed to a ver
-
tical, load-bearing surface. The test set is then clicked into the
supporting bracket.
The following mounting materials are included in the scope of
delivery:
−
3 wood screws 4.5 x 60 mm and 3 universal plugs 5 x 30 mm
for attaching the supporting bracket to the surface
−
2 self-tapping screws
for securing the test set
NOTICE!
The mounting materials supplied may be unsuitable for certain
surfaces. If the mounting material is nevertheless used in such
cases, the supporting bracket may rip away from the surface after
the test set has been inserted.
●
Only use the supplied mounting material if it is suitable for the
surface intended for mounting.