SENKO P 10 WATER+AIR Slim Modern, Instruction Manual

Page: 51 / 84

SENKO pellet SLIM MODERN stoves
–
Instruction manual
50
When the stove begin with shut down, the electronics start to countdown
the time (factory set) of 40 min . At the end of this period (40 min) the
electronics control the room temperature. If the room temperature is
constantly more
than 23°C (set) MINUS 3°C
(factory set)

so if
temperature is more than 20
°C, the stove doesn’t start again.
The stove
will start ( IGNITION
→ ON
) again only when : 40 min has passed AND
the room temperature is LESS than 20
°C (e.g. 19°C).
This function can be found in Settings menu under Eco . You can
activate this function by clicking on it OR clicking inside the empty
box to get the green checkmark . Eco appears on the display - see ( 13 )
on Figure 22b. To turn off Eco mode follow the same procedure.

ECO mode remains active until it is set off from the Settings menu!

This operating mode is recommended only for stoves installed in
well-insulated rooms with insignificant heat loses!

Please note that after several re-ignitions and because of unburned
pellets (ash) in the burner pot, could result in bad ignition of new
inserted pellets

possible release of smoke into the room!
Therefore please clean the burner pot if necessary.

In manual mode ( MANU ), it is possible to enable ECO only if the
room thermostat is active - otherwise, AUTO must always be active !
5.6.4. WARM AIR FAN (
FAN
)
As previously mentioned, the stove is
equipped with a warm air fan, which heats
the space through grid on the stove front
side. You can set 5 different blowing
speeds depending on the operating mode
the stove is in (AUTO or MANU).
In AUTO mode , the fan speed is related
to the stove heating power. E.g. if the heating
Table 5