SENKO P 10 WATER+AIR Slim Modern, Instruction Manual

Page: 24 / 84

SENKO pellet SLIM MODERN stoves
–
Instruction manual
23
Installation of horizontal parts should be avoided as much as
possible. When parts in question are those which must reach let-offs on the
ceiling or walls unsymmetrical with the stove smoke let-off, the connection
is to be executed via pipes with incline
s not exceeding 45° (
figure 10 ).
When installing the flue pipes, please follow the instructions below:

horizontal parts must have a
minimum 3°
upward incline,

the length of horizontal part must be kept at minimum, and should not
exceed 3 m.

number of elbows (
90° angles) should not exceed 4 (including the T-
piece)
– should you need more than 4 elbows, use a pipe with internal
diameter of

120 mm),

chimney diameters exceeding 120 mm are not suitable for direct
connection to the stove, and a suitable, min. 80 mm diameter flexible
smoke venting pipe (made from acid-resistant stainless material), is to
be conducted through such a chimney and the chimney is to be
insulated to prevent cold air from penetrating into the flue pipe!

connecting the stove to a chimney of wider diameter will result in
increased thermal loss of the stove, with subsequent increase in the fuel
consumption !
The stove is connected to the chimney with flue pipes with
minimum
diameter of

80 mm (pipe length up to 3 m ), OR

100 mm (with pipe
length exceeding 3 m ). The length is obtained by adding the parts of the
horizontal and vertical pipes, keeping in mind that each 90° elbow
corresponds to 1 linear metre.
CAUTION!
DO NOT CONNECT the flue pipe to a common flue pipe
used for other heat generators (water heaters, fireplaces, cookers and
similar)

see figure 11 .