SENKO pellet SLIM MODERN stoves
–
Instruction manual
45
5.5.
IGNITION / SHUT DOWN
The stove is
turned ON
by pressing
the
ON/OFF
key on the control
panel
for the duration of 2 seconds
(key 1
–
Figure 22a
). The control
panel will produce an audio signal and the screen will display the
IGNITION
option.
After initial ignition which may last up to 20 minutes maximum (
#
-
see next page
) (
every subsequent ignition lasts 5 - 10 minutes
), the stove
gradually achieves normal operation status.
The first attempt to activate the stove may not be successful since
the pellet feeder (spiral) is completely empty at the beginning and
does not distribute the same quantity of pellets into the firebox every
time. In that case, the control panel produces and audio signal and
alarm A01 appears on the screen (
see
Table 13
and
Figure 36
)!
Cancel the alarm on the control panel (
hold the green button for
longer than 2 seconds
), wait until the stove has cooled to the state OFF,
clean the burner pot and repeat stove ignition sequence !
If, after reactivation (around 20 minutes), the pellets are not yet ignited,
check whether the burner pot is properly set. The burner pot must
completely adhere to its casing and must not contain any ash
.
Figure 26
2 sec
Summary of Contents for P 10 WATER+AIR Slim Modern
Page 1: ...INSTRUCTION MANUAL SN EN 719 PELLET STOVES SLIM MODERN P 8 AIR 8 kW P 10 WATER AIR 12 kW...
Page 14: ...SENKO pellet SLIM MODERN stoves Instruction manual 13 Figure 1a P 8 AIR SLIM MODERN...
Page 15: ...SENKO pellet SLIM MODERN stoves Instruction manual 14 P 10 WATER AIR SLIM MODERN Figure 1b...
Page 71: ...SENKO pellet SLIM MODERN stoves Instruction manual 70 Figure 43 a b c d e f g h...
