36
|
MAGIQTOUCH & MAGIQCOOL MODELS
BRAEMAR LCQI EVAPORATIVE
COOLER
cont
MOTOR REPLACEMENT FOR LCQI
COOLERS
Step 1 Isolate power
Isolate the cooler mains power supply at the
site’s electrical switchboard.
Step 2 Removing the control box
Place the on/off switch mechanism on the
electronics module to the “O” (off) position.
Remove the screw securing the electronics
module to the tank and remove the electronics
module. Unplug the two motor leads from the
electronics module.
Step 3 Removing the venturi assembly
If required, remove the two screws securing
the venturi assembly either side of the tank
(Fig. 1). Remove the venturi assembly from the
tank (Fig. 1).
Step 4 Remove the motor cable tether
Snip the cable tie holding the cables to the
motor cable tether and remove the screws
securing the motor cable tether to the motor
end casing and the venturi. Remove the ferrite
clamp attached across both motor cables.
Step 5 Remove the fan
Turn the venturi assembly over, so that the
assembly is resting on the top of the motor.
Using a hex driver unfasten the set screw
holding the fan to the motor shaft and remove
the fan (Fig. 2).
Step 7 Replacing the motor
Remove the motor and reassemble the venturi
& motor mount to the new motor. Orientate the
through hole with the triangle indicators to the
larger tab on the motor (Fig. 3). Replace the
four screws to secure the motor to the venturi
& motor mount.
Step 6 Removing the motor
Unscrew the four screws holding the venturi
& motor mount to the motor, and remove the
venturi & motor mount (Fig. 2).
FAN
SET SCREW
(STEP 5)
4 OFF SCREWS
(STEP 6)
MOTOR
REST ASSEMBLY ON
MOTOR END CASING
(STEP 5)
VENTURI &
MOTOR MOUNT
ORIENTATE TRIANGLE
INDICATORS TO LARGER
MOTOR TAB
ENSURE SCREWS
ARE REMOVED
Fig. 1
Fig. 2
Fig. 3
