10
|
MAGIQTOUCH & MAGIQCOOL MODELS
INSTALLATION OPTIONS
INSTALLATION WIZARD
DEFAULT SINGLE COMPONENT
The first screen of the System Definition phase
gives the below options:
DEFAULT SINGLE COMPONENT
can be
used for an installation containing only a
single cooler (or heater without zones), without
sensors, and where the installer wants to apply
only default settings.
No further definition is required. The installation
process is completed automatically by the
controller.
MULTIPLE COMPONENTS
For all other installation types the MULTIPLE
COMPONENTS option must be selected.
This will commence the Installation Wizard
which steps through the steps of System
Definition and Installation.
PHASE 1 - SYSTEM DEFINITION
For multiple component systems the
installation wizard begins with a “System
Definition” phase. The installer must define
exactly what components will be installed. The
screens that follow will depend on what has
been defined.
PHASE 2 - INSTALLATION
Do not worry about memorising a particular
sequence of screens for this process. The
steps and screens the controller moves
through may change depending on the
installation. Simply follow the instructions
displayed on the screen.
Just remember… Do not
power-up/connect
components until instructed to do so by the
controller!
And if the controller can’t detect a component
or comes across a fault, it will tell you and give
instructions of how to fix the problem.
If any problems occur during the installation
phase it is possible to reset the whole system
and start again from the beginning.
ILL1783-A
ILL1861-A
ILL1611-B
