3 Assembly and start-up
SCHMIDT
®
ServoPress 605-660
– V1.1
13
3.5 Adjusting the working area
Constructive restrictions
CAUTION
Damage to the press or to the tool
The available operating stroke is limited by various system functions (e.g.
initialization/ reference run, spindle lubrication, etc.). These system
functions move the ram above or below the topmost position.
Make sure that the execution of system functions does not result in
collisions with the tool or tools.
During tool construction, include a corresponding adapter in the
planning if necessary.
After the reference run, which is used to tare the force measurement, the
ram moves to the TDC position. The taring takes place via the spindle
rotation.
If the reference run is started in a position ≥ the value under point 3 "Max.
stroke during reference run from home position", the stroke is ended 0,5 mm
above the parameterized TDC position.
Figure 7: Restrictions of the working stroke (example)
Press
605
616
617
620
650
660
1
Ram extension at home
pos. (top working pos.) [mm]
40
50
60
60
60
67
2
Max. negative stroke [mm]
- 20,5
- 22,2
- 21,9
- 15,4
- 7
0
3
Max. stroke during ref. run
from home position *
[mm]
+ 5,5
+ 5,5
+ 11
+ 5,5
+ 11
+ 22
* If the reference run is not started from the home position but lower, the ram moves in negative
direction.
Adjusting the working stroke
The individual parameters of the working stroke are defined in the control
unit.
For further information, refer to the "Instructions for Use - SCHMIDT Manual
workstation"
respectively
the
"Assembly
Instructions
-
SCHMIDT
Components for automation".
Ram extension at home
position
