4 Maintenance and servicing
SCHMIDT
®
ServoPress 605-660
– V1.1
19
Swing the grease gun out of the housing.
Pay attention to existing cables and hoses.
Press the unlocking lever on the grease gun.
Fully extend the plunger rod.
Unscrew the grease gun housing.
Remove the empty grease cartridge.
Remove the covers on the new grease cartridge.
Place the new grease cartridge into the grease gun housing in the
direction of the arrow.
Screw the grease gun housing into place.
Make sure that the housing is properly secured.
Push the plunger rod completely into the grease gun.
Swing the grease gun into the housing.
Pay attention to existing cables and hoses.
Secure the grease gun via the mounting screw.
Carefully loosen the bleed screw and bleed the grease cartridge.
Tighten the bleed screw again hand-tight.
Reinstall the back cover of the press.
Figure 12: Replacing the grease cartridge (example)
1
Back cover
2
Plunger rod
3
Unlocking lever
4
Grease gun
5
Bleed screw
6
Mounting screw
Press type
Amount of
grease
required
Grease
Material no.
650-660
400 cm
3
KLÜBERPLEX BEM 34-131N
554906 (grease
cartridge)
