19
20
Normal
Normal
+/- Indicator
+/- Force
[+/-Normal] /
[+/-Reverse]
/- signs of force
value. [Normal]
+: compression, -: tensile.
[Op: tensile,
-: compression
+/-
Displacement
[+/-Normal] /
[+/-Reverse]
/- signs of
displacement value.
(*2)
* 1 Selectable units differ between Japan model and non-Japan model.
* 2 A test stand with linear scale option is needed to measure displacement.
[OFF] /
[Type A] /
[Type B] /
[Type C] /
[Type D] /
[Type E] /
[Manual]
Displacement
Type
—
OFF
Select when connect with
displacement scale. Refer
to the operation manual of
test stand for detail.
Enable to manually set at
[Manual]. Refer to the
page 28-29 for detail.
7. Initial Setting
1. Turn off power.
2. Hold (MENU button) and turn on power with (ON/OFF button).
3. Select menu in Main menu with (ON/OFF, ZERO buttons), and go to
Sub menu with (PEAK button). (Some menu doesn’t have Sub menu.)
4. Select menu in Sub menu with (ON/OFF, ZERO buttons), and go to
Setting menu with (PEAK button).
Go back to Main menu with (SEND button).
5. Select menu in Setting menu with (ON/OFF, ZERO buttons), and enter
the setting with (MENU button).
(The setting can be saved only when entered with MENU button.)
6. The display automatically goes back to Sub menu after entering.
Go back to Main menu with (SEND button).
7. Push to show ‘Exit Menu’ and go back to measurement-ready
display with (MENU button).
* Push and hold (MENU button) more than 2 seconds for the same action.
ZTA/ZTS
eZT
ZTA
eZT
ZTA
eZT
(*2)
[Max] /
[High] /
[Medium] /
[Low]
Sensitivity
—
Max
Change sensitivity of force
measurement. [Max] is the
highest sensitivity. [Max] is
suitable for rapid change
like impact test.
ZTA/ZTS
eZT
Initial Setting (Setup Menu)
Main menu
Sub menu
Setting menu
Description
Initial setting
[N] / [kN] / [mN] /
[gf] / [kgf] / [ozf] /
[lbf]
(*1)
(Valid selection
differs depending
on capacity.)
Units
Force Units
N basis
Change force units.
Valid model
ZTA/ZTS
eZT
mm
Displacement
Units
[mm] / [°] /
[inch]
(*1)
Change displacement units
ZTA
eZT