Scanivalve MPS4264, Hardware And Software Manual

Page: 9 / 99

3
MPS4264
Table of Contents
General Control Commands 41
Boot Loader Version 41
Firmware Files Check 41
Format Flash Disk 42
Multiple Unit Find 42
Multiple Unit Stop 42
Reboot 42
Status 43
Stop 43
TAR File Unpack 43
Valve State 44
Version 44
PTP (Precision Time Protocol) Commands 45
Clear Accumulated PTP Statistical Data 45
Display PTP Statistics 45
Get PTP Time 45
Get Scan Start Time 45
Get UTC Offset 46
Set PTP Time 46
Scan and Calibration Commands 47
Calibration 47
Multiple Unit Calibration 47
Calibration & Validation 47
Multiple Unit Calibration & Validation 48
Max-Min Calibration Table Values 49
Read Current Temperature 49
Scan 50
Multiple Unit Scan 50
Software Frame Trigger 50
Validation 51
Multiple Unit Validation 51
Zero Offset Calibration 51
Save Commands 52
Save 52
Scan Variables 53
List Scan Settings (LIST S) 53
Set Rate (RATE) 53
Set Frames Per Scan (FPS) 53
Set Scan Units (UNITS) 54
Set Scanning Data Format (FORMAT) 55
Set Trigger (TRIG) 55
Set Enable FTP (ENFTP) 55
Set Options (OPTIONS) 56
UDP Variables 57
List UDP Settings (LIST UDP) 57
Set UDP Enable (ENUDP) 57
Set the UDP Target Address and Port (IPUDP) 57
Identification Variables 58
List Identification Settings (LIST ID) 58
Set Serial Number (SN) 58
Set Nominal Pressure Range (NPR) 58
Set the Multiple Device Multicast Address (MCAST) 58