Scanivalve MPS4264, Hardware And Software Manual

Page: 68 / 99

62
MPS4264
Section 5: Software
Precision Time Protocol Variables (LIST PTP)
The precision time protocol settings control the PTP 1588 settings of the MPS4000. The PTP configuration is accessed by the
command LIST PTP.
LIST Precision Time Protocol Settings (LIST PTP)
DESCRIPTION Returns all of the PTP settings
SYNTAX LIST PTP
RETURNS All of the PTP setting followed by the prompt.
EXAMPLE
LIST PTP
SET PTPEN 1
SET STAT 0
SET SST 0:0:0.000000
SET SSD 1971/1/1
SET UTCOFFSET -7:00:00
>
Set PTP Enable (PTPEN)
DESCRIPTION Enables the precision time protocol engine in the MPS4000. When PTPEN is set to 2, the MPS will
serve as a PTP master
SYNTAX SET PTPEN <0-disable, 1-enable, 2-enable as master>
RETURNS Prompt when ready to accept a new command
EXAMPLE SET PTPEN 1
>
DEFAULT 0
RANGE 0, 1 or 2
Set PTP Statistical Output (STAT)
DESCRIPTION Sets the destination of PTP statistical output
SYNTAX SET STAT <level code>
Where <level code> is:
0 – off
1 – serial
2 – network
The statistical data is output in the following format:
<ofm>, <msd>, <smd>, <mpd>
ofm - Offset From Master. Time that slave and master differ in units of microseconds
msd - Master to Slave Delay. Filtered packet delivery time from master to slave
smd - Slave to Master Delay. Filtered packet delivery time from slave to master
mpd - Mean Path Delay. Filtered mean path delay time
RETURNS Prompt when ready to accept a new command
EXAMPLE SET STAT 0
>
DEFAULT 0
RANGE 0 to 2