Scanivalve MPS4264, Hardware And Software Manual

Page: 61 / 99

55
MPS4264
Section 5: Software
Set Scanning Data Format (FORMAT)
DESCRIPTION Set the format of the scanned data for each of the destinations: Telnet, FTP and Binary Server.
SYNTAX SET FORMAT <destination> <format code>[,<destination> <format code>,<destination> <format
code>]
Where:
<destination> is:
T-Telnet (only A, F and C format code apply)
F-FTP (only A, C, B, and S format codes apply)
B-Binary server (only B,L and S format codes apply)
<format code> is:
A-ASCII
F-Formatted ASCII
C-CSV format
B-Binary format (.dat) See binary format definition below.
L-LabVIEW binary format. See binary format for LabVIEW definition below.
S-Statistical data (.dat) See statistical binary format definition below.
RETURNS Prompt when ready to accept a new command
EXAMPLE
SET FORMAT T F, F B, B B
>
DEFAULT T F, F B, B B
Set Trigger (TRIG)
DESCRIPTION Sets the frame trigger
SYNTAX SET TRIG <trig>
When trig is set to 0 frame trigger is internal.
When trig is set to 1 frame trigger is external or triggered with the TRIG command or <TAB>
key.
When trig is set to 2, external scan trigger is configured.
When trig is set to 3 auto scan is enabled (see “Auto Scan Option” on page 24)
RETURNS Prompt when ready to accept a new command
EXAMPLE SET TRIG 0
>
DEFAULT 0
RANGE 0, 1, 2 or 3
NOTES Setting TRIG to 2 requires a SAVE S command followed by a reboot in order for the change to take
effect.
Set Enable FTP (ENFTP)
DESCRIPTION Enables or disables sending data to the users FTP server.
SYNTAX SET ENFTP <0-Disable, 1-Enable>
RETURNS Prompt when ready to accept a new command
EXAMPLE
SET ENFTP 1
>
DEFAULT 0
RANGE 0 or 1