
SATEL GSM-4/GSM-5
41
Configuring the reporting
Reporting
– if this option is enabled, the module can report to monitoring station.
For the modules with built-in industrial-type GSM telephone other than the u-blox
LEON-G100 telephone, enabling the reporting feature will disable the feature of
PAGER message conversion into SMS messages.
INTEGRA presence supervision [Tst.con.INTEGRA]
– if this option is enabled, the status
of connection with INTEGRA control panel through RS-232 port is monitored.
Events buffering [Events buffer]
– the option is available in the module with built-in GSM
u-blox LEON-G100 telephone. If it is enabled:
each event received from the control panel is acknowledged at once,
events (both received from the control panel and generated by the module) are
recorded in the event log (see: section "Events buffer" p. 47).
If the option is disabled, depending on the reporting link, receipt of the event is
acknowledged to the control panel by:
GPRS / CSD / AUDIO – GPRS / CSD / AUDIO – after acknowledgement of the event
receipt by the monitoring station;
SMS – after sending the SMS message.
If the events buffering option is enabled, the event codes are not sent through the
AUDIO link.
Reporting test send all media [Test all links]
– if this option is enabled, the module test
transmission is sent over all links which have been programmed using the "Links to MS1 /
Links to MS2" function. If the "Events buffer" option is enabled and the test transmission is
sent over all links, the "Events buffer" tab will only display the event communicating
information about test transmission sent over the reporting link programmed as the last
one.
Number of reporting retries before sending other way [Attempts/link]
– the number of
unsuccessful retries to send the event over the given reporting link, after which the module
will make an attempt to send the event over the next link. You can program values from 2
to 255 (by default: 3).
Kiss off time [Kissoff period]
– duration of the tone generated by the module to
acknowledge receipt of the event from the alarm control panel. The entered value must be
suitable for the reporting format selected in the control panel. You can program values
from the 100 to 2550 ms range (by default: 850 ms).
Reporting station 1/2
Station addr. [MS1 address / MS1 address]
– network address of the monitoring station. It
can be entered as an IP address (4 decimal numbers separated by dots) or as a name.
Port [MS1 port / MS2 port]
– the number of TCP port on which transmission of events to the
monitoring station will take place.
The
port number must be consistent with that
programmed in the monitoring station.
Station key [MS1 key / MS2 key]
– a sequence of up to 12 alphanumeric characters (digits,
letters and special characters) defining the key with which the data sent to the monitoring
station will be encrypted.
It must be consistent with that programmed in
the monitoring station
.
System identifier [MS1 sys.ident. / MS2 sys.ident.]
– 4 characters (digits or letters from A
to F), used to identify the module. They must be programmed, if events generated by the
module are to be reported, or in the case of GPRS reporting. The value 0000, which is
entered by default, means no identifier.