
SATEL GSM-4/GSM-5
27
2. Enter the old access code and click on the "OK" button
3. Enter the new access code and click on the "OK" button.
4. Enter again the new access code and click on the "OK" button.
The program allows to get access based on additional codes which can be programmed and
for which authority level can be defined (in the "File" menu, select "Configuration", and then
"Dload10 users" – see: Fig. 16).
6.2.6 "GSM-4 / GSM-5" tab
Shown in square brackets are the names of functions as presented on the module
display.
Fig. 17. "GSM-5" tab (GSM-5 module).
Password
GSM identifier [GSM ident.]
– a sequence of up to 6 alphanumeric characters to identify the
module during communication with the D
LOAD
10 program. Connection between the
program and the module can only be established when the identifiers in program and
module are consistent. In the module with factory settings, the AAAAAA value is
programmed. After establishing communication, this value can be changed. The entered
value can be seen when you click on the
button. The identifier is also used during
communication with the STAM-1 / STAM-2 monitoring station.
Service code
– a sequence of up to 8 digits which enables you to get access to the service
mode. If the code is programmed, enter it (see p. 21) at an attempt to start the service
mode in the module, when the "Service code" message is displayed. If the code is
unknown or invalid, you will only be able to enter the service mode after restoring the
factory settings ("Delete all (123=Yes)" message).