Hardware Configuration
PR 5610 Installation Manual
20 Sartorius
3.2.1 Installing the options
Board 1 is provided with 3 identical sockets (double row, 2*25 contacts) for options. The designation for the
sockets (from left to right) is slot 1 ... 3. The plug-in card connections are taken identically from each slot to 16-
pole terminal blocks. For application packages the option cards are plugged into fixed slots, which cannot be
changed later.
For detecting the options a COLD start has to be performed!
Option slot 3 (most right) and terminal B (upper block) in
use.
Installation: layer side left, component side right
Attention: position plug exactly above contact pins!
Set both rows correctly in the holes of the plug.
The optional plug-in cards are provided with pin
markings and port addresses (list for each slot) as
well as connecting examples, as far as necessary.
The upper row of the terminal blocks is called B, the
lower A.
The terminals are described A1, A2, .... A8 and B1,
B2, .... B8 (A1 is the most left pin of row A).
3.2.2 Digital Board (Board 2)
On board 2 the processor, memories, two RAM extension sockets and display connection are located. The display
board is mounted below board 2. At the top left corner the battery jumper is located, the battery itself is found
on the layer side of the board.
Board 2 contains a 50-pole connector called slot 4. After plugging in the option, the card has to be locked by
two screws.
For detecting the options a COLD start has to be performed!
