Sanyo DSR-5709P, Instruction Manual

Page: 108 / 236

RECORD SET 2
English
107
13
Turn the shuttle dial clockwise.
“OFF” flashes.
14
Turn the jog dial to select “OFF” or a
sensitivity level between “1” to “10” and
then turn the shuttle dial clockwise.
The cursor moves to “MODE”.
[Settings] ( ‹ indicates default setting)
15
Turn the shuttle dial clockwise.
“A” flashes.
16
Turn the jog dial to select the “MODE”
setting and then turn the shuttle dial
clockwise.
The cursor moves to the top left sensor.
[Settings] ( ‹ indicates default setting)
17
Use the same procedure to set “LEVEL”
and “MODE” for “T-2” through “T-4”.
z Motion sensor positions are common for “T-1” through “T-
4” and different settings cannot be made.
18
Turn the shuttle dial counter-clockwise.
Motion sensor settings are confirmed and the <ALARM REC
MODE SET> screen is displayed once again.
Setting sensitivity levels
Setting Description
‹ OFF Motion sensing is disabled.
1 to 10
Motion sensing is enabled. Lower numbers
correspond to higher levels of sensitivity.
Setting sensor modes
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-1 LEVEL : OFF MODE : A
A
Setting Description
‹ A
The motion sensor alarm is triggered when a
moving object is detected in A.
B
The motion sensor alarm is triggered when a
moving object is detected in B.
A AND B
The motion sensor alarm is triggered when a
moving object is detected by a sensor in both A
and B.
A AND NB
By setting A to important points (moving objects)
and B to non-moving points, the motion sensor
alarm is not triggered when the overall screen
brightness changes. The motion sensor alarm
only activates when A experiences a change
and B does not.
A TO B
The motion sensor alarm is triggered when an
object is detected moving from A to B. (within 2
seconds from A to B)
B TO A
The motion sensor alarm is triggered when an
object is detected moving from B to A. (within 2
seconds from B to A)
CH01 T-1 LEVEL : OFF MODE : A
A