SANY SY500H, Operation And Maintenance Manual

Page: 79 / 196

MACHINE OPERATION
4-9 SY500H Excavator OMM
Opening the Left Rear Access Door
To open the left rear access door (1), unlock and pull the
latch (2). When fully open, place the access door support
rod in the support bracket slot to prevent the door from
closing unexpectedly. See “Access Door Support Rod”
on page 4-7.
Closing the Left Rear Access Door
Move the support rod out of the slot in the support
bracket to close the access door. See “Access Door
Support Rod” on page 4-7. Close the access door until it
is latched securely.
Left Front Access Door
0004958
Figure 4-11
Opening the Left Front Access Door
Open the left rear access door. See “Opening the Right
Rear Access Door” on page 4-8. Open the left front
access door (1) by pulling on the rear of door and
swinging it toward the front of the machine. When fully
open, place the access door support rod in the support
bracket slot to prevent the door from closing
unexpectedly. See “Access Door Support Rod” on
page 4-7.
Closing the Left Front Access Door
Move the support rod out of the slot in the support
bracket to close the access door. See “Access Door
Support Rod” on page 4-7. Close the access door. To
secure the door, close the left rear access door. See
“Closing the Left Rear Access Door” on page 4-9.
Fuel Filler Cap
NOTICE!
• Make sure the O-ring on the filler cap is clean. If
the O-ring is contaminated by dirt or debris, it
could be damaged and not seal properly.
• Inspect the O-ring for wear or damage. Replace if
necessary.
• Make sure the filler cap is fully seated before
turning the key to lock or unlock the cap.
• Close the lock shield when not in use to prevent
dirt and debris from entering the lock.
Failure to follow this notice could damage the
machine or cause it to operate improperly.
0004760
Figure 4-12
Opening the Fuel Tank Filler Cap
Slide open the lock shield (1) on the filler cap (2).
Insert the key into the lock.
NOTE: Insert the key fully into the lock. The key may
break if it is turned before it is fully inserted.
Turn the key and remove the filler cap.
Closing the Fuel Tank Filler Cap
Install the filler cap (2) onto the filler tube. Insert the key
into the lock, turn and remove the key. Close the lock
shield (1).
1
2
1