SANY SY500H, Operation And Maintenance Manual

Page: 41 / 196

MACHINE CONTROLS
3-11 SY500H Excavator OMM
Radio Control Panel
0005263
Figure 3-10
Radio Operation
NOTICE!
The radio could easily be damaged if penetrated
by water. When washing the machine, take care
not to spray water on the radio. Wipe the radio
with a dry cloth.
NOTE: The battery disconnect switch and the key switch
must be ON for the radio to operate.
Universal Serial Bus (USB) Port
The USB port (1) allows the operator to interface
computers or other electronic devices through the radio
port.
Auto Scan/Preset Station (AS/PS) Button
Press and release the AS/PS button (2) to begin the auto
scan feature. Each preset station will play for 10 seconds
with the currently playing station frequency blinking on
and off on the LCD screen (6). Press the AS/PS button
once more to remain on the current station.
Press and hold the AS/PS button for 2 seconds to
activate the auto programming feature. In auto
programming, the six radio stations with the strongest
signals are stored in the six preset buttons (10).
FM/AM Selector Button
Press the FM/AM selector button (3) to toggle between
AM1/AM2 and FM1/FM2 bands. Each band can have
different preset stations selected.
Audio Selection (SEL) Button
Use the audio selection button (SEL) (4) to adjust the
sound tones and speaker left/right balance. Each time
the button is pressed, the display will cycle to adjustment
options as follows:
• Press and hold the SEL button to access the bass
adjustment.
• Press and release the SEL button again to access
the treble adjustment.
• Press and release the SEL button again to adjust
the cab speaker balance.
With the audio option selected, use the VOL (+) or the
VOL (–) button (8) to adjust the audio level.
NOTE: If the audio selection button is not pressed after 5
seconds, the display defaults to the current radio
station frequency.
Time Display/Time Set Button
Press and release the time display/time set (TIME)
button (5) to display the set time for 5 seconds.
While the time is being displayed, press and hold the
button to enter the time set screen. The hour numbers
will flash. Press the tuning control arrows (9) to set the
desired hour.
To set the minutes, press and release the button again
and the minute numbers will flash. Press the tuning
arrows to set the desired minutes.
Press and release the button to leave the time set screen
and return to time display for 5 seconds. The time display
will return to the radio display.
1 Universal serial bus (USB) port 5 Time display/time set (TIME) button 8 Volume (VOL) control buttons
2 AS/PS selector button 6 Liquid crystal display (LCD) 9 Tuning control buttons
3 FM/AM selector button 7 Power button 10 Preset station buttons
4 Audio selection (SEL) button
7
5 4
1
3
6
2
10
9
8