8
1. Place conveyor frame upside down on table. (Assembly is easier this way.)
2. Install control unit delivered in separate packaging. → See p.1
2. (For constant-speed type using 200V
2.
three-phase power source, controller is optional.)
3. If return rollers are delivered in separate packaging, stickers RETURN ROLLER FIXING POSITION are
2.
affixed on side of frame. Return roller attachment tap pieces are temporarily bolted into frame
2.
underside slots, just under the stickers. Install return rollers using the tap pieces as shown in figures
2.
below. (Return rollers are individually packed and temporarily attached beside drive unit.)
NOTE: 1. For center drive type of 2m or less in length, machine has no return roller.
2. In the following cases, return rollers are delivered already installed as shown in fig. 1, i.e.
installation is unnecessary.
-3m or less in machine length and 60mm in frame depth
-3m or less in machine length, 30mm in frame depth and 300mm or less in belt width
3-1. INSTALLING STANDS AND RETURN ROLLERS
3
ASSEMBLY
Installation will become easier by inserting
and tightening bolt into end of tap piece.
4. Stands(optional) are delivered in separate packaging. Install them using the attached stand tap pieces.
NOTE: 1. Install each stand in appropriate position
referring to “Standard Installation Positions of
NOTE: 1.
Stands”, p.
9.
NOTE:
2. For machine length of 1.2m or less, stand tap pieces are delivered inserted into conveyor frame.
5. When assembly is completed, turn over the entire conveyor and place on the floor.
6. Adjust conveyor height following “Stand Height Adjustment”
on next page. Confirm full
6.
length of frame is straight and level on top, and firmly tighten stand bolts and nuts.
Summary of Contents for S-CON MINI-Z Series
Page 1: ...1 S CON MINI Z Series OPERATING AND SERVICE MANUAL...
Page 35: ...35 MEMO...
