26
9
MOTOR REPLACEMENT
Replace motor following procedure below:
1. Remove cover-R(*1) and bottom cover(*2).
2. Remove motor side sprocket(*3) and roller chain(*4).
3. Loosen motor base attachment bolts(*5)(4 bolts), and remove motor with motor base.
NOTE: For vertical-axial motor type machine of 100mm in belt width, also remove side plate-L(*6).
→See p.
25.
4. Remove motor and gear head attachment bolts(4 bolts), and replace motor and gear head.
5. Reinstall parts in reverse order. Properly adjust roller chain tension.
10
DRIVE UNIT RELOCATION
It is possible to move drive unit(*1) along frame(*2). If necessary, relocate drive unit as follows:
1. On right and left drive unit covers, mark initial position(L1) of take-up pulley. To loosen belt, turn take-
1.
up knobs(*3) clockwise.
2. Loosen bolts(2 bolts on each side) and remove right and left drive unit covers.
3. Loosen drive unit attachment bolts(*4)(4 bolts on each side).
4. Move drive unit to intended position. On right and left sides of conveyor, measure length(L2) to ensure
1.
drive unit side plates are positioned equally on both sides. Then retighten drive unit attachment
1.
bolts(*4).
5. Reinstall drive unit covers. Turn take-up knobs(*3) until take-up pulley returns in initial position(L1), i.e.
1.
take up belt slack properly. Then adjust belt alignment.
Summary of Contents for S-CON MINI-Z Series
Page 1: ...1 S CON MINI Z Series OPERATING AND SERVICE MANUAL...
Page 35: ...35 MEMO...
