14
4
RUNNING THE CONVEYOR
4-1. BE SURE TO GROUND MACHINE BEFORE OPERATION
4-2. STARTING CONVEYOR
1. Constant-speed Type
Push illuminating-
start switch into “RUN” position. To stop machine, push it to “STOP” position.
NOTE: This switch is not for turning power on and off. When leaving conveyor unused for a long period,
make sure that it is unplugged or mains is off.
100V single-phase power source
：
Ground earth terminal (green) of power cable plug.
200V single-phase power source
：
Connect earth terminal (green) of power cable to power cable plug
with an earth.
200V three-phase power source
：
Standard machine has only lead wire terminal. For constant-speed
type, switch etc. are not provided. When wiring, properly provide an
earth on motor or drive side plate.
●
Power cable and terminals
2. Speed-controller Variable-speed Type
(1) Make sure RUN/STOP switch on speed controller is in “STOP” position. Turn on power supply and
ensure that power-on indicator is illuminated.
(2) Set RUN/STOP switch to “RUN” position. Motor will star
t rotating and conveyor will run. (When
setting RUN/
STOP switch, make sure that it is completely either in “RUN” or “STOP” position, but
not halfway.)
(3) To increase speed, turn speed control clockwise; to decrease speed, turn it counterclockwise. Set
appropriate speed for intended use.
(4) To stop conveyo
r, set RUN/STOP switch to “STOP” position.
NOTE: This switch is not for turning power on and off. When leaving conveyor unused for a long period,
make sure that it is unplugged or mains is off.
AC 100V single-phase
Earth (green)
Power cable plug
AC 200V single-phase
Earth (green sleeve)
Power (red sleeve)
Constant speed type
Illuminating-start switch
Power-on indicator
(LED illuminated when powered.)
Speed control
RUN/STOP switch
Model code
Speed controller
Variable speed type
Summary of Contents for S-CON MINI-Z Series
Page 1: ...1 S CON MINI Z Series OPERATING AND SERVICE MANUAL...
Page 35: ...35 MEMO...
