12
NOTE: If it is necessary to install control unit
NOTE:
separately from drive unit, use
NOTE:
extension cable (optional) to make
NOTE:
connection as shown in figure, right. (If
NOTE:
necessary, remove control unit cover
NOTE:
to connect connectors. In this case be
NOTE:
sure to reinstall control unit cover.)
■
Caution When Joining Frames and Setting up Conveyor
1. Install full length of frame straight, not bent in any place.
2. Finely adjust conveyor level. (Use level adjusters beneath stands.)
NOTE: If conveyor is bent or not level on top, belt may stray to one side or the other.
￥
If control unit is delivered in separate packaging, install it as follows:
NOTE: For constant-speed type using 200V three-phase power source, standard machine has only lead
NOTE:
wire terminal of motor, control device is optional.
Unpack control unit. Install it near drive unit by tightening control unit attachment bolts (insert-able
bolts)(*1) into underside slot of frame, as shown in figure below.
NOTE: For control unit with micro-inverter, similarly install it.
3-3. INSTALLING CONTROL UNIT
Control unit
Power supply cable
Extension cable
(optional)
Connector
Drive unit
Motor cable
Motor
Summary of Contents for S-CON MINI-Z Series
Page 1: ...1 S CON MINI Z Series OPERATING AND SERVICE MANUAL...
Page 35: ...35 MEMO...
