25
8
BELT REPLACEMENT
Replace belt following procedures below:
1. Remove stands from conveyor. (If difficult, on opposite side of drive unit chain, remove all the stand
1.
attachment bolts.)
2. Remove all the return rollers, if any.
3. Remove take-up pu
lley. →See p.
24.
4. Remove cover-L(*2) on opposite side of chain.
5. On the same side, remove drive unit side plate-L as follows:
(1) For correct re-assembly, mark initial position of drive unit side plate-L on frame.
(2) Slide right and left clips(*1) outward, and remove bottom cover(*3).
(3) Remove the following bolts from drive unit side plate-L:
-Drive unit attachment bolts(*4)(4 bolts)
-Brace (SZ) attachment bolts(*5)(2 bolts)
-Drive pulley bearing attachment bolts(*6)(2 bolts)
-Brace attachment bolts(*7)(2 bolts)
-Snub pulley bracket attachment bolt(*8)(1 bolt)
(4) Remove snub pulley bracket and drive unit side plate-L.
NOTE: Do not change snub pulley adjustment bolt(*9) condition.
6. Remove head (or tail) pulley from frame end. →See p.
24.
7. Remove belt sideways and install replacement belt.
NOTE: In advance, check replacement belt for length, straightness, etc. When installing, pay attention to
NOTE:
direction of belt travel.
8. Reinstall parts in reverse order. Take up belt and adjust belt alignment.
Summary of Contents for S-CON MINI-Z Series
Page 1: ...1 S CON MINI Z Series OPERATING AND SERVICE MANUAL...
Page 35: ...35 MEMO...
