32
Frame depth
Model code
30mm
SZS
，
SZSV
60mm
SHZS
，
SHZSV
13
TILT MODELS
13-1. COMPONENT NAMES
13-2. TILT ANGLE ADJUSTMENT
Be sure to switch off power supply and adjust tilt angle as follows:
1. On both sides of conveyor, loosen tilt fixing nuts(*1)(M8, 2 nuts on each side) with a spanner. Hold
1.
head tilt frame(*2) with your hand, and set it at intended angle.
2. To fix the tilt angle, retighten all the tilt fixing nuts(*1).
NOTE: 1. Before retightening tilt fixing nuts(*1), make sure that these are equally adjusted on both sides
NOTE: 1.
of conveyor.
NOTE:
2. If setting at a larger angle, slightly loosen belt with take-up device before angle adjustment.
NOTE: 1.
After fixing the tilt angle, take up belt slack.
For assembly, operation and belt take-up, see p.8-19.
13-3. BELT ALIGNMENT ADJUSTMENT
When belt is not correctly aligned, make adjustment as follows.
For prior checking and adjustments except in tilt unit, see p. 21-23.
Adjustment Using Bend Pulley of Tilt Unit
When belt is deviating in tilt unit, on side to which belt is deviating,
slightly move bend pulley outward on this side by turning
adjustment screw(*2). Belt will then center itself. Alternatively,
on opposite side, if there is a space between pulley bracket and
frame end, make adjustment on this side. In this case slightly
move bend pulley inward by turning adjustment screw(*2).
■
Bend Pulley Removal
Loosen fixing bolts(*3) of pulley retaining blocks(*4) with hexagonal wrench. Remove pulley retaining
blocks(*4) upwards, and then remove bend pulley upwards.
Applied models:
Summary of Contents for S-CON MINI-Z Series
Page 1: ...1 S CON MINI Z Series OPERATING AND SERVICE MANUAL...
Page 35: ...35 MEMO...
