Samson Media 7 5007-1, Mounting And Operating Instructions

Page: 121 / 124

EB 9510 EN 17-1
Annex B
17 Annex B
17.1 Accessories
17.1.1 Valve block
Three valves are combined in the valve block
for Media 7. The valve block is bolted onto
the bottom of the Media 7 dp cell (see
Fig. 17-1).
The valve block offers the following bene-
fits:
− Mounting of an operating pressure
gauge possible.
− Fastened using two additional mounting
holes.
− The connected measuring lines can be
bypassed. This allows a zero calibration
of the differential pressure to be
performed regardless of the current
filling level of the tank.
− The differential pressure meter can be
easily removed by shutting off the mea-
suring lines (e.g. to replace a defective
device) without disturbing the running
process.
− Lead-seal holes
Î
Details on the valve block:
see accessories for the Media Series
u
T 9555
17.1.2 Further accessories
A list of available accessories for the Media
Series can be found in the Data Sheet
u
T 9555.
17.2 After-sales service
Contact our after-sales service for support
concerning service or repair work or when
malfunctions or defects arise.
You can reach our after-sales service at
aftersalesservice@samsongroup.com.
Addresses of SAMSON AG and its subsid-
iaries
The addresses of SAMSON AG, its subsid-
iaries, representatives and service facilities
worldwide can be found on our website
(www.samsongroup.com) or in all SAMSON
product catalogs.
Required specifications
Please submit the following details:
− Order number and position number in
the order
− Type, serial number, firmware version,
device version