Samson 3730-4, Mounting And Operating Instructions

Page: 135 / 212

EB 8384-4 EN
135
Physical Block, Slot 0 · Profile-specific parameters Appendix
Description
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
Command to reset the positioner to default values
Resets the start-up, identification and function block parameters as well as the status classification
Note:
After performing a reset, the positioner needs to be re-initialized!
Warm start
Resets the bus address to the default value of 126. The positioner restarts after the reset is performed.
Note:
The bus address can only be reset using this command in firmware version K 1.11 and higher. The bus
address is not reset when the identification parameters are reset.
Resets the identification parameters
Resets the start-up and function block parameters as well as the status classification
Note:
After performing a reset, the positioner needs to be re-initialized!
Resets the start-up parameters
Note:
After performing a reset, the positioner needs to be re-initialized!
Physical Block:
CONFIG_BINARY_INPUT_2
1)
, DEVICE_INSTAL_DATE, DEVICE_MESSAGE, DESCRIPTOR,
IDENT_LIMIT_SWITCHES
1)
, IDENT_NUMBER_SELECTOR, TAG_DESC, TEXT_INPUT 1 to 5
1)
AO Function Block: TAG_DESC
AO Transducer Block: ACTUATOR_MAN, ACTUATOR_SER_NUM, ADD_GEAR_ID, ADD_GEAR_INST_DATE,
ADD_GEAR_MAN, ADD_GEAR_SER_NUM, DEVICE_CALIB_DATE, DEVICE_CHARACT 1) ,
DEVICE_CONFIG_DATE, TAG_DESC VALVE_MAINT_DATE, VALVE_MAN, VALVE_SER_NUM, VALVE_TYPE
DI1/2 Function Block: TAG_DESC
DI1/2 Transducer Block:
SENSOR_ID, SENSOR_MAN, SENSOR_SER_NUM, TAG_DESC
Status classification, analysis of
Physical Block: COND_STATUS_DIAG, DIAG_EVENT_SWITCH, DIAG_EVENT_SWITCH_2
1)
, FEATURE
Physical Block: ALERT_KEY, FACTORY_RESET, FEATURE_SELECT, LOCAL_OP_ENA, ST_REV, STRATEGY,
TARGET_MODE, WRITE_LOCKING
AO Function Block: ALERT_KEY, BATCH, CHECK_BACK_OPT, FSAFE_TIME, FSAFE_TYPE, FSAFE_VALUE,
IN_CHANNEL, INCREASE_CLOSE, OUT_CHANNEL, OUT_SCALE, PV_SCALE, SIMULATE, ST_REV, STRATEGY,
TARGET_MODE
AO Transducer Block: ACTUATOR_ACTION, ALERT_KEY, CHARACT_TYPE 1) , SELF_CALIB_CMD,
SELF_CALIB_STATUS, ST_REV, STRATEGY, TARGET_MODE
DI1/2 Function Block: ALERT_KEY, BATCH, CHANNEL, FSAFE_TYPE, FSAFE_VAL_D, INVERT, SIMULATE,
ST_REV, STRATEGY, TARGET_MODE
DI1/2 Transducer Block: ALERT_KEY, SENSOR_WIRE_CHECK, ST_REV, STRATEGY, TARGET_MODE
1)
Manufacterer-specific parameter