Samson 3730-4, Mounting And Operating Instructions

Page: 134 / 212

134
EB 8384-4 EN
Appendix Physical Block, Slot 0 · Profile-specific parameters
Parameter Index SK Access Mode Selection/display [default value] Description
FACTORY_RESET
35 S r/w ALL
1 (0x0001). . . . . . . . . . . . . . . . . . . . . . . . . . . .
2506 (0x09CA) . . . . . . . . . . . . . . . . . . . . . . . .
2712 (0x0A98) . . . . . . . . . . . . . . . . . . . . . . . .
32768 (0x8000). . . . . . . . . . . . . . . . . . . . . . . .
32769 (0x8001). . . . . . . . . . . . . . . . . . . . . . . .
32770 (0x8002). . . . . . . . . . . . . . . . . . . . . . . .
Command to reset the positioner to default values
Resets the start-up, identification and function block parameters as well as the status classification
Note:
Warm start
Resets the bus address to the default value of 126. The positioner restarts after the reset is performed.
Note:
address is not reset when the identification parameters are reset.
Resets the identification parameters
Resets the start-up and function block parameters as well as the status classification
Note:
Resets the start-up parameters
Note:
Identification parameters
. .
(without bus address, valve
and actuator data)
Physical Block:
IDENT_LIMIT_SWITCHES
AO Function Block:
AO Transducer Block:
ADD_GEAR_MAN, ADD_GEAR_SER_NUM, DEVICE_CALIB_DATE, DEVICE_CHARACT
DEVICE_CONFIG_DATE, TAG_DESC VALVE_MAINT_DATE, VALVE_MAN, VALVE_SER_NUM, VALVE_TYPE
DI1/2 Function Block:
DI1/2 Transducer Block:
Start-up parameters . . . . . .
Status classification, analysis of
condensed status (Code 36)
Physical Block:
Function block parameters . Physical Block:
TARGET_MODE, WRITE_LOCKING
AO Function Block:
IN_CHANNEL, INCREASE_CLOSE, OUT_CHANNEL, OUT_SCALE, PV_SCALE, SIMULATE, ST_REV, STRATEGY,
TARGET_MODE
AO Transducer Block:
SELF_CALIB_STATUS, ST_REV, STRATEGY, TARGET_MODE
DI1/2 Function Block:
ST_REV, STRATEGY, TARGET_MODE
DI1/2 Transducer Block:
1)