salmson DIE, Installation And Starting Instructions

Page: 94 / 272

English
88 Pompes Salmson 04/2012
Display orientation
5.7.2.0 Pressure value cor-
rection When pressure value correction
is enabled, the differential pres-
sure deviation measured by the
differential pressure sensor that
is factory-fitted on the pump
flange is taken into account and
corrected. Only displayed in Δ p-c mode.
Is not displayed for all pump
variants.
Pressure value correction Off
Pressure value correction On
5.7.6.0 SBM function Setting for behaviour of signals
SBM run signal
SBM readiness signal
SBM mains On signal
5.7.7.0 Factory setting OFF (default setting)
Settings are not changed by
confirming. Is not displayed when access
disable active.
Is not displayed when build-
ing management system
active
ON
Confirming will reset the set-
tings to factory settings.
CAUTION!
All manual settings will be lost.
Is not displayed when access
disable active.
Is not displayed when build-
ing management system
active
6.0.0.0 Error acknowl-
edgement For additional information, see
Section 11.3 “Acknowledging
errors” on page 99. Only displayed if an error is
present
7.0.0.0 Access disable “Access disable” inactive
(changes possible)
(for further information, see
8.6.7 “Activating/deactivating
access disable” on page 82)
“Access disable” active (no
changes possible)
(for further information, see
8.6.7 “Activating/deactivating
access disable” on page 82)
No. Designation Type Symbol Values/explanations Display conditions
±
±
±
±
±