Sailor 250 FleetBroadband, User Manual, Page: 154 / 288

Chapter 4: Using the web interface
138 Setting up the interfaces
Configuring the I/O interface
To configure the I/O pins, do as follows:
1. Select SETTINGS > Discrete I/O .
2. For each pin you want to use, select Enabled .
3. For each pin, select the function of the pin. Refer to the previous section,
I/O pins and their functions on page 135.
4. If you are using the Ignition function and you want the terminal to stay on
for a few minutes after the Ignition is switched off, enter the number of
minutes under
DELAYED SHUTDOWN .
For further information on the Ignition function, see Using the ignition
system on page 24.
5. If you are using a ringer output, select the incoming call types that should
activate the ringer under RINGER OUTPUT .