Configuration
38 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
Meaning:
TTTT
= the duration of the time out :
Min value =
40
0
: 400
*10
ms = 4 s
Max value =
1200
: 1200 * 10 ms = 12 s
Recommended value: 600 (= 6 s)
Option: If activated you can stop the dial timeout by pressing
#
after the last entered
digit of the phone number (fast dialling key). (Default: Not activated; to activate this
function please check the User manual)
8.7.3
Flash signal detection (used to manage two calls
simultaneously)
The TELSAT GPRS is capable to detect the so called Flash signal.
On most telephone sets the Flash signal is sent by pressing the
R
key. In some
seldom cases the length of the Flash signal of a telephone differs from the standard the
TELSAT GPRS is configured for by default. If the TELSAT GPRS does not detect the
Flash signal of your telephone in the right way please adjust the setting of the TELSAT
GPRS using the following DTMF codes:
For the Phone port:
Description:
*5
ACCESS
014
MIN
#
Minimum duration
*5
ACCESS
015
MAX
#
Maximum duration
For the Fax/Modem/Phone port:
Description:
*5
ACCESS
016
MIN
#
Minimum duration
*5
ACCESS
017
MAX
#
Maximum duration
Meaning:
All Flash signals with a duration >
MIN
and <
MAX
will be detected.
With
MIN
=
7
....
55
: that means 70 ms .... 550 ms
With
MAX
=
12
....
65
: that means 120 ms .... 650 ms
8.7.4
Enable / Disable SMS Configuration
Remote configuration of you TELSAT GPRS is possible by sending special SMS (SMS
= Short Message Service) to the device. This function can be enabled/disabled:
Default access code:
000000
Default access code:
000000
