Parameters in the file para.ini: advanced configuration
102 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
Section:
DIALLING
Meaning
Parameter
Permitted Values Factory Setting
Polarity reversal
on/off on port A
CHA_POLARITY_REV YES,NO
NO
Polarity reversal
on/off on port B
CHB_POLARITY_REV YES,NO
NO
16.26 Hang-up delay
Can be configured by SMS (see page 83)
Can be configured by FTP (see page 84)
This function allows, in case of an incoming call to answer the call, to hang-up the call
and to continue the call, if you pick-up the phone again within the selected delay, if the
remote party has not yet terminate the call. This function is always active, if the
Polarity reversal has been activated. If the Polarity reversal function is off you may
activate the Hang-up delay by parameter.
Section:
DIALLING
Meaning Parameter
Permitted
Values
Factory Setting
Hang-up delay
on/off port A
CHA_MTC_HOOK_DELAY YES,
NO
NO
Hang-up delay port
A
CHA_MTC_HOOK_TIMEOUT 0....30000
6000 = 1min
Hang-up delay
on/off port B
CHB_MTC_HOOK_DELAY YES,
NO
NO
Hang-up delay port
B
CHB_MTC_HOOK_TIMEOUT 0....30000
6000 = 1min
16.27 MNP Flow Control
Can be configured by SMS (see page 83)
Can be configured by FTP (see page 84)
The Microcom Networking Protocol MNP is used for error correction and flow control
on the link to the local connected Modem. If you want MNP active set the following
parameter as follows: MNP=YES
.
Section:
MODEM
Meaning Parameter
Permitted Values
Factory Setting
MNP setting
MNP
YES,NO
YES
