For experienced Users: AT commands
64 TELSAT
GPRS
Datei 8123AD010_11.doc
Datei gespeichert
08.03.04 17:31 von EDV/ORGA
Druckzeit 08.03.04,
17:44
Status Release
Command
Function
(factory setting in bold print)
ATD
[
n
]
Dial number
Parameters:
n =
String of dialling digits and optionally V.25ter modifiers
(dialling digits): 0-9, * , #, +, A, B, C
ATE[
n
]
Command echo
Parameters:
n =
0: Echo mode off
1: Echo mode on
ATH[
n
]
Hang up
Parameters:
n=
0: Terminate call
ATI[
n
]
Output product code
0 ‘RT-3000 DNT8115/8123’ (example)
3 ‘Firmware Version: 1.004’ (example)
4 ‘GSM-Module-Firmware: SAGEM JE3,7D’ (example)
8 Output supported operating modes (see ATB)
9 Identification of the modem and the mobile phone
ATQ[
n
]
Specifies whether or not the device transmits any result code to
the connected TE. Information text transmitted in response is not
affected by this setting.
Parameters:
n =
0: result codes transmitted by TA
1: no result code transmitted by TA
ATS0=
n
Writes value
n
into status register
0
.
Set number of rings before
automatically answer the call. This command is valid only for
data calls.
Parameters:
n = 0: automatic answering deactivated
1-255: number of rings before automatically answering
ATS0?
Displays the value of status register 0
ATS3=
n
Writes the value
n
into status register 3
.
This parameter
determines the character recognised by TA to terminate an
incoming command line (13 = <CR> by default)
Parameters:
n= 0 – 127 : command line termination character
ATS3?
Displays the value of status register 3
ATS5=x
Writes the value
x
into status register 5. Determines the
command line editing character.
Parameters:
n= 0 – 127 : command line editing character
ATS5?
Displays the value of status register 5
