Saci Pumps emotion MT2-11A, Installation And Maintenance Manual

Page: 46 / 262

46
EN
Max. Min. Default
Units Description Par.
Programming
Notes
5.56
5.57
5.58
5.60
5.61
5.62
5.63
5.64
5.59
6.08
1
YES
YES
0,5
NO
NO
NO
NO
99
NO
NO
99,9
YES
YES
YES
YES
OFF
PTC
NTC
4,8
9,6
19,2
5
YES
YES
1
NO
NO
NO
NO
OFF
19,2
Sec
kohm
kbps
Time from when the system calculates a low water level until the moment the alarm
is activated for this reason.
Parameter for enabling or disabling the detection of the broke pipe.
Parameter for enabling or disabling the alarm due to a power cut.
By this parameter, set the trigger level of motor thermistor connected.
YES: Editing the values of the parameters is locked.
NO: Editing the values of the parameters is unlocked.
To change this parameter from YES to NO, you must enter the password 1357 or
another password generated previously by the user.
When you change this parameters to “YES” this screen for editing the date and time
will appear. Once editing is completed, the parameter returns to “NO”.
If you change this parameter from “NO” to “YES” the stop frequency search wizard
will be launched.
To reset the unit and leave it with the factory settings, change this parameter to
“YES” and after you have entered the code 1357 the unit will launch the start-up
wizard.
By this parameter, select the type of motor thermistor available for motor protection.
DRY RUNNING ALARM
DELAY
BURST PIPE ALARM
VOLTAGE ALARM ACTIVE
MOTOR THERMISTOR
TRIGGER LEVELL
PARAMETER LOCK
SET DATE AND TIME
STOP FREQUENCY SEARCH
WIZARD
FACTORY DEFAULT RESET
MOTOR THERMISTOR TYPE
MODBUS BAUDRATE
To enter menu 6, a password is required (2468)
If installed on a borehole pump, it is reccomended to modify the 6.04 value (switching frequency) to minimum (2.5 kHz).
ATTENTION: Before modifying the menu 6 parameters, please contact our assistance service as, incorrect settings could cause improper functioning of the inverter and/
or pump damage.
6.01
6.10
6.11
6.02
6.04
6.09
6.05
6.06
6.07
0
NO
NO
0,1
2,5
0
0
1
1
100
NO
NO
100
7,7
0
kHz
0,1 Bar
1
1
999
YES
YES
999
16
2
0,5
64
250
If you change this parameter from “NO” to “YES” you will reset the alarms log and
the parameter automatically returns to “NO”.
If you change this parameter from “NO” to “YES” you will reset the number of start-
ups and the parameter automatically returns to “NO”.
0=even // 1=odd // 2=no parity
PROPORTIONAL
CONSTANT
ALARM LOG RESET
START-UP NUMBER LOG
RESET
INTEGRAL CONSTANT
SWITCHING FREQUENCY
MODBUS PARITY
STOP MANEUVER
FREQUENCY
SPEED OF STOP
MANEUVER
MODBUS ADDRESS
6. FINE TUNNING
Max. Min. Default
Units Description Par.
Programming
Notes