Saab R5 SUPREME AIS, Operation & Installation Manual

Page: 55 / 156

R5
SUPREME - Navigation System
CONFIGURATION
7000 118-301, A3 Page 55
how often they are sent. The views are accessed by pressing Main Menu

Maintenance

Configuration

Interface

Output .
In the output sub view for each user port, current data load for the port is displayed.
This gives an indication on how much of the port‘s baud rate that is used up by the
enabled sentences. Only turn on the sentences that you intend to use.
For a list of output sentences available on the different serial ports, refer to section 9.2
and chapter 10.
It is also possible to output correction data from the internal DGPS beacon receiver in
RTCM format on User port 2. This function is available only if the R5 SUPREME CDU
is used together with an R4 DGPS Navigation Sensor with routing software version
1.07 or higher.
Current routing software of the Navigation sensor can be viewed in the SW/HW Info
view described in section 5.11.10.
If this function is available, an ‗RTCM‘ option will be added to the list of output
messages in the
User Port 2 Output Configuration view as illustrated below.
Figure 17
– User Port 2 Output Config
It is possible to interleave RTCM output data with the ordinary NMEA style text
messages on the User port 2. However, this may be a problem for receiving equipment
and thus it is recommended that all other User Port 2 output messages shall be set to
‗Disabled‘ when this feature is used.
The baud rate for RTCM output data is controlled by the ‗User Port 2‘ rate parameter in
the
Port Rate Configuration view. Selectable rates are 4800, 9600 and 19200.