Saab R5 SUPREME AIS, Operation & Installation Manual

Page: 52 / 156

R5
SUPREME - Navigation System
CONFIGURATION
7000 118-301, A3 Page 52
Allow External ACK
If set to ―Enabled‖
all alarms will be acknowledged if
the binary alarm ACK signal is triggered.
If set to ―Disabled‖, the binary alarm ACK signal will be
ignored.
See section 13.2.4.2
―Alarm Acknowledge Binary Port‖
for more information about external ACK signal.
ACK Disables Discrete Output
If set to ‗Yes‘, the alarm discrete output signal will be
reset as soon as all active alarms have been
acknowledged.
If set to ‗No‘, the alarm discrete output signal will be
active as soon as there are any active alarms,
regardless of acknowledgement state.
See section 13.2.4.3
―Alarm Out Binary Port‖ for more
information about the alarm discrete output signal.
4.2.12 Port Rates
This view is accessed by pressing Main

Maintenance

Configuration

Interface

Port Rates
In this view it is possible to configure the baud rate for the four different User ports in
the R5 Navigation System, as well as the pulse rate of the Speed Log output.
User Port 1 has a maximum baud rate of 38400 bps.
User Port 2 has a maximum baud rate of 19200 bps
User Port 3 and 4 can be configured up to 115200 bps.
The higher the baud rate, the more sentences can be output on the specific port. In the
Output Config views (see section 4.2.17) an estimated port load is calculated
depending on the selected baud rate and the configured output sentences.
The Speed Log output can be set to:
Disabled (default)
100 Pulses/NM
200 Pulses/NM
300 Pulses/NM
400 Pulses/NM
4.2.13 Own CDU Settings (Network)
This view is accessed by pressing Main Menu

Configuration

Interface

Network

Own CDU Settings
Parameter Name Description
CDU IP Address The Internet Protocol (IP) address of the R5 SUPREME
CDU.