RDC6563F Standalone Fiber Cutting Control System User Manual V2.0
99
SHENZHEN RUIDA TECHNOLOGY CO., LTD
4) After the setting is successful, click the [Enter] button to complete the device
connection.
8.3 Ethernet device connection
The procedures to connect the mainboard via Ethernet (network cable) are as follows:
1) Open RDCutist software, Click the [Device Connection] button in the lower right corner
of the software.
2) Click the [Add] button to add the network device, and then set the network IP address
correctly. The IP address is 192.168.1.XXX, and XXX indicates any number between 2
and 254. If there are multiple devices connected to the same LAN, please note that the
IP addresses of different mainboards cannot be the same. Otherwise, the IP address
conflict will cause the connection to fail.
