RDC6563F Standalone Fiber Cutting Control System User Manual V2.0
103
SHENZHEN RUIDA TECHNOLOGY CO., LTD
9.1 Common Troubleshooting Methods
Common
Troubleshooting
phenomenon
Reason
Solution
Manually move by Z
axis on the panel,
the cutting head
does not move
The servo drive is not wired
correctly
Refer to the user manual for
proper wiring.
Servo
drive
parameter
settings are incorrect
Set the parameters correctly
according to the servo drive
manual
Servo drive does not support
speed control mode
Please select a drive that
supports speed control mode
An alarm occurs on the Z axis
of the main board, causing to
stop.
Eliminate
alarm
faults
according to alarm prompts
on the panel interface
The panel is not connected
properly with the mainboard.
1
、
Check if the panel cable
2
、
Z-axis movement can be
controlled by
XY Axis manual
does not move
The servo drive is not wired
correctly
Refer to the user manual for
proper wiring.
Servo
drive
parameter
settings are incorrect
Set the parameters correctly
according to the servo drive
manual
The polarity of the limit is set
incorrectly, causing to stop.
Correctly set the limit polarity
Servo drive generates an
alarm
Please restart the servo to
cancel the alarm.
Communication
failed via USB
connection
USB driver not installed
properly
Please install the USB driver
correctly
The mainboard and computer
are not connected to the USB
cable or the cable is faulty.
Please replace the USB
cable to ensure that the USB
connection is normal.
Not set to USB connection
properly
Please set the connection
method to USB connection
Communication fails
via Ethernet
Network IP settings are
incorrect
Please set the mainboard IP
address correctly.
