Page 1: ...circuit On Model SWL25 only connect the third conductor for calf in to terminal T Trigger Connector or Bus Wiring L There are three terminals OFF A 0 at the ends of the switchbank that will be interconnected in a factory wired system These interconnections provide loop through for common functions especially between multiple switch banks For wiring details read the instruction manual for the prope...
Page 2: ... small PC board that is perpendicular to the board with the selector switches Note that each switch is connected to a trace on either side of this bus board Cut the traces as needed and make any connections to the solder pads on the bus board The C bus conductors can be easily cut with a sharp knife to isolate the C lines for multiple master operation Use the low numbered switches 1 2 3 etc for ma...
Page 3: ...SW 25 SWITCHBANK KC1334 A P I I I I I I I P I 1 I I I ...
Page 4: ...SWL 25 SWITCHBANK KC1335 B N r 1 i I ...
