RTS Zeus III, User Manual

Page: 37 / 70

Zeus III Installation 37
Bosch Security Systems, Inc. Technical Manual F.01U.193.289 Rev. 05
Ethernet Configuration
There are two (2) ways to connect the Zeus III to AZedit over Ethernet:
•
Using a straight CAT-5 Ethernet cable and connecting to an existing IP Network.
•
Using a fabricated CAT-5 crossover cable and connecting directly to the AZedit computer. (For the
CAT-5 crossover cable pin out, see Figure 21 on page 29.)
NOTE: The straight CAT-5 cable assembly cannot be directly connected to the computer with AZedit loaded on it. It can
only be used with a router or switch that is connected to the computer. Use the CAT-5 crossover cable to directly
connect to the Zeus III with Ethernet.
To configure the Zeus III for Ethernet configuration using the supplied Ethernet cable , do the following:
1.
Attach the Ethernet cable to your existing IP network using a network router or switch.
2.
Attach the other end of the Ethernet cable to the Ethernet connector located on the rear of the Zeus III.
NOTE: By default, Zeus III is shipped with the IP Address 192.68.0.9 and the Network Mask 255.255.0.0.
To change the IP Address, initially you must connect either serially or via USB.
FIGURE 27.
Straight Cat-5 Ethernet Connection