44 Installation
Zeus III
Bosch Security Systems, Inc.
Technical Manual
F.01U.193.289
Rev. 05
Keypanel Configuration
To
configure a typical keypanel system
, do the following:
>
Using an RJ-45 keypanel cable, connect the
cable
to a keypanel port (ports 1 to 32) located on the back of the Zeus
III unit.
NOTE:
For the pin out of the RJ-45 keypanel cable, see Table 2 on page 15.
Trunking Configuration
To
configure a trunking system
, do the following:
1.
Connect a
serial cable to the TRUNK/TO PC connector
located on the rear panel of the Zeus III unit.
2.
Connect the other end of the
serial cable to the serial cable connector
located on the back of the MTM-2000.
3.
Use
TrunkSupervisor/Editor to configure the Zeus III trunking system
(for trunking configuration information,
see the TM-2000/MTM-2000 User Manual – 93507715000).
FIGURE 36.
Keypanel Configuration
FIGURE 37.
Trunking Configuration
Summary of Contents for Zeus III
