131
B.1
Disclaimer
The contents of all safety data sheets in this manual are subject to the following
disclaimer. The safety data sheets have been compiled to the best of our knowledge and
belief as a short instruction regarding safe handling of ROWE Scan 600 devices. We
reserve the right to revise safety data sheets if new findings are on hand.
It is the customer's responsibility to check if this information is exhaustive, to deduce all
required safety precautions, and to make sure that the most recent version of the data
sheet is on hand by contacting ROWE in this respect.
Insofar as permitted by law, we do not accept any liability for completeness and
correctness of these safety data sheets.
B.2
Safety Information
The ROWE Scan 600 devices have been designed and manufactured according to the
state-of-the-art. However, health hazards and risks of property damage may occur during
use.
Operators shall use the ROWE systems in proper technical condition, according to the
intended use, being aware of safety and hazards, and observing this Operating Manual. In
particular failures impairing safety have to be eliminated immediately.
The ROWE systems of the Scan 600 series shall exclusively be used as described in this
Operating Manual. Another use or use exceeding the above shall not be deemed intended
use. The manufacturer is not liable for damages resulting therefrom. Solely the user
bears the risk for the above.
All persons dealing with erection, commissioning, operation, and maintenance of the
device shall be appropriately skilled and trained. In order to ensure their safety it is
important to observe the Operating Manual thoroughly.
B.3
Prior to Installation
Read the Operating Manual including the safety notes. Also ensure that all operators read
the Operating Manual. The documents as to the device shall be stored close to the device
where they can be found easily by any operator. Check the conditions at the intended
place of installation.
B.3.1
Conditions of Room
Provide for the following conditions:
There shall be sufficient space around the scanner so that it is easily accessible
from all sides.
Sufficient ventilation of the system shall be ensured.
We recommend to install the device in a place without any vibrations if possible
(e.g. not close to a large-sized punching machine).
The relative humidity of air shall amount to 30 to 60 %.
Summary of Contents for Scan 600-20
